Good morning,

Multiple times a day, we have to create a particular feature on many blocks. (example is attached)

We need a sphere (but must be a surface, and not a solidbody) with a sketch point at its center.

It needs to be created 12.7mm from a surface face, along an axis of an existing hole.

I have tried MANY times, in a variety of different ways to record this macro so that we can cut down this repetative task.

Ideally, im thinking I would select the face, and the intersecting hole for the axis, and then with those seleted, run the macro.

Is there anyone available that can help offer a solution to this?   

Any input is appreciated.

Thanks,

Mark