I have two assemblies that should be moving in curved roller tracks in synchronization. Can I simulate or see their movement in SW 2013 Professional or do I need Premium to do that?
If you can figure out how to do the mates properly, you should be able to do it in SW Standard.
Thanks for the response. I am doing it in Professional, but in sequence, i.e. suppressing and unsuppressing mates depending on position. I wanted to see if there is a way without suppressing and unsuppressing.
Without seeing you assembly it is hard to say. Can you post the assembly or a simplified version for us to see your setup.
Attached is a picture of the setup: a cart and a chute both with rollers inside guides. the thick round shaft is welded to the chute and the thin one to the cart arm and this shaft rotates inside the two bearings welded to the chute.
Retrieving data ...