AnsweredAssumed Answered

Cant Convert to sheet metal, edges will not rip/bend

Question asked by Leo Dolan on Feb 14, 2014
Latest reply on Feb 15, 2014 by Simon Hayward

Hello,

 

I am trying to convert this shape that I have attatached into 2mm sheet meal, it is to be lazer in a flat net and welded together to form the final shape.

 

It is the first time I've really used convert to sheet metal, I have only seen people use it before and as you will see it is not letting me convert any of the shape apart from the top and bottom shapes

 

I'm aware the angles are quite tight in the corners  and probably wouldnt be able to bend there but this is where i was planning to rip,I would like to keep the shape and rip then and weld along the edges where it goes to a point.

 

Any help/advice would be really appreciated :-)

Attachments

Outcomes