running solidworks 2010
can split a b.o.m. just fine, but no option to split a revision table?
theres so many revisions on the drawing the stack is larger than the drawing sheet. need to split the revision table but can't figure out how.
For anyone thats ending up here looking for a way to split a revision table, in solidworks 2010, splitting a revision table is not possible.
not sure about more recent releases
You really have a need to keep that much revision history on your drawing? I think most people simple start deleting old revisions from the table when it starts getting long.
Posted this problem from a previous employer, they were sticklers about keeping every single revision on the drawing.
Just got on here today and saw that this discussion has been viewed quite a bit, so wanted to throw the second post on there so everyone looking saw it..haha
thank goodness my current employer is ok with me cutting out old revisions when needed...lol
Sounds like a more reasonable employer now - best of luck!
Retrieving data ...