4 Replies Latest reply on Feb 19, 2014 2:29 PM by Dan Armstrong

    Importing from DXF, is there any way to round all dimensions to the nearest thousandth?

    Dan Armstrong

      Hello all,

           I was curious about the idea of rounding imported dimensions.  I often import  (dxf / dwg) and dimmensions of lines are always very close to nominal mm/in (ex: 39.9998754 -> 40).  Is there any program option I am missing or equation, etc. that would allow you to "adjust" all dimensions to the nearest tenth, thousandth, etc. ??


      Thanks very much!