Skip navigation

5 Replies Latest reply on Mar 31, 2014 6:16 AM by Denny Peter

Opening the sub assembly in the assembly, It crashes

Poornakkumar Palanisamy Feb 7, 2014 3:44 AM

Hi,

When i am opening the sub assembly in the assembly, It crashes. let me know, what is the problem.

Thanks,

Poornakkumar P

1.PNG 22.2 KB

Re: Opening the sub assembly in the assembly, It crashes

Kedar Powar Feb 7, 2014 3:50 AM (in response to Poornakkumar Palanisamy)

Please check if you are meeting SW recommended hardware requirements.

-K
Like Show 1 Likes(1)

Actions
- Re: Opening the sub assembly in the assembly, It crashes
  
  Poornakkumar Palanisamy Feb 7, 2014 4:05 AM (in response to Kedar Powar)
  
  K KEDAR. YES IT RECOMMENDED HARDWARE BY SOLIDWORKS.
  
  Like Show 0 Likes(0)
  
  Actions
Re: Opening the sub assembly in the assembly, It crashes

Ananda Ganesh Madheswaran Feb 7, 2014 4:41 AM (in response to Poornakkumar Palanisamy)

Hi Poorna,
Check for any change in the Service packs
Like Show 0 Likes(0)

Actions
- Re: Opening the sub assembly in the assembly, It crashes
  
  Poornakkumar Palanisamy Mar 31, 2014 5:58 AM (in response to Ananda Ganesh Madheswaran)
  
  all service packs have same issue
  
  Like Show 0 Likes(0)
  
  Actions
Re: Opening the sub assembly in the assembly, It crashes

Denny Peter Mar 31, 2014 6:16 AM (in response to Poornakkumar Palanisamy)

Hi Poornakumar

Run Rx file and upload the results, some one may help to find the reason
Like Show 0 Likes(0)

Actions

Go to original post

More Like This