Hello,
please forgive me if this has been noted before, I searched arounda bit and found nothing on this. Perhaps it is just me, Buthere goes, When exporting as an Adobe document form SW 07 i havenoted that if a part has two configurations then thats whatyou export. For example i have two configs of the same part, a LHand a RH. I have two Prints, a LH and a RH. whenexporting either to adobe i get the full config when i open the pdffile. is there a work around?
thanks in advance
mark
please forgive me if this has been noted before, I searched arounda bit and found nothing on this. Perhaps it is just me, Buthere goes, When exporting as an Adobe document form SW 07 i havenoted that if a part has two configurations then thats whatyou export. For example i have two configs of the same part, a LHand a RH. I have two Prints, a LH and a RH. whenexporting either to adobe i get the full config when i open the pdffile. is there a work around?
thanks in advance
mark