Hello guys, please help me to mold design about this part
thank you very much
First thing I notice is that you don't have any dimensions.
If I roll up the feature tree to the first extrusion and try to start a new sketch on the parting surface - I can't select it.
I have never seen this problem before.
The extrusion doesn't match the sketch profile.
On a part this simple, you cannot figure out how to do it by just reading the help examples?
(And as J. Mather noted, sketches without dimensions are a very, very bad habit to get into and will eventually cause big problems.)
Doug Seibel wrote: On a part this simple, you cannot figure out how to do it by just reading the help examples?
Doug Seibel wrote:
Did you try it?
There seems to be something wrong with the first feature that does not see that "planar" face.
I would start over - but I am curious about why that geometry appears to be corrupt to me (right from the beginning extrusion).
I just opened the file & Boss Extrude1 is showing how it should on my system. What's strange is that in your screenshot you are showing the first feature as using contours in the sketch, where as on mine it is just using the rectangular geometry....strange!!
I have to go back and check what I did before - I opened on a different machine and everything looked as expected.
Boss-Extrude10 does not make logical sense. The bottom face should not have been selected when doing the Shell feature.
I also noticed that face draft is missing on much of the part.
Is this going to be a blow mold? If so, you don't want to shell the part.
Have you gone through the tutorials?
Retrieving data ...