0 Replies Latest reply on Jan 20, 2014 11:29 AM by Alexander Sandstrom

    Modifiying Dowel Pin Symbols

    Alexander Sandstrom

      Hello Everyone,

       

      I have always learned, when detailing with a dowel pin symbol, that only one quadrant is shaded. SolidWorks shades two of the quadrants which I would normally use as my pilot hole symbol (See picture for difference). I was wondering if there is any way to modify the symbol that SolidWorks uses for dowel holes in order for them to be the same as what I have used for the past years.

       

      Dowel Pin.PNG

       

      Thank you in advance,

      Alex