2 Replies Latest reply on Jan 17, 2014 4:19 PM by Kelvin Lamport

Orientaion of an Assembly and Assemblies that Follow After

Cadster Tigweld Jan 21, 2014 10:35 AM

Hi Guys

I am trying to Orientate this Assembly so that when i click the Isometric (and Side/Top etc) It Orients properly.

I am adding new Assemblies into this Asembly ( I attached a File Labeled Assem 1) How do I make Sure all the new ones that get added Orient Themselves according to this Newly Adjusted one .

Thank you

See Attachment

Assemb 1.SLDASM.zip 601.1 KB

Re: Orientaion of an Assembly and Assemblies that Follow After

Jerry Steiger Jan 17, 2014 3:36 PM (in response to Cadster Tigweld)

Cadster,

I didn't open your attachment, but I don't understand what your question is. How are you adjusting the orientation of your assembly? Are you changing the way the initial part is mated? Are you changing the view definitions using the Update Standard Views button?

Jerry S.
Like Show 0 Likes(0)

Actions
Re: Orientaion of an Assembly and Assemblies that Follow After

Kelvin Lamport Jan 17, 2014 4:19 PM (in response to Cadster Tigweld)

When posting an assembly file, all the components must be included in a ZIP file.
Like Show 0 Likes(0)

Actions

Go to original post