Jay Lovelady

Linear pattern crash

Discussion created by Jay Lovelady on Jan 10, 2007
Latest reply on Jan 10, 2007 by Jay Lovelady
We have loaded in SW 2007 sp2.0 and have an interesting problem. When we hit "Linear Pattern" in a part, SW locks up and kicks us out. It isn't just one or 2 systems either. Every system we have tried it on does the same thing. We can use the linear pattern in a sketch, but not in a part.

Has anyone else run into this yet, or does anyone have a suggestion as to what we can look into?

Any and all comments are appreciated.

Outcomes