Flats are not coming out correct, any thoughts?
try delete holes in sketch in base flange1
Kurt elimate your angle cuts in the edge flange it'll unfolds fine, then add separate angle cuts on a line by
themselves then it unfold, just something SW dose some times, you can use edge flange as you did but
add a short striaght line before your angle line and that works fine in the jpeg file you'll see the line marked
.100" could be .001" and it unfolds fine.
my suggestion would be to go back to your original sketch1 and remove the angled section, then remove the sketched bend 1 and create another edge-flange, flatten and add holes and you should be all set. Tom
Retrieving data ...