Supress & Unsupress Flipping in 2007 SP1.1

Discussion created by Devon Sowell on Jan 5, 2007
Latest reply on Jan 23, 2007 by Devon Sowell

Like • Show 0 Likes0
Comment • 2

For example, a Part file with multiple Configurations;

I Edit a Feature that is Unsupressed in all Configurations. After Rebuilding and Saving, then Reopening, that same Feature is Supressed in all the other Configurations, except for the one it was Edited in.

Outcomes

2 Replies

1-75IWCO Jan 23, 2007 2:28 PM
I had a problem once with features suppressing themselves (so Ithought). When actually, I had a setting turned on thatneeded to be disabled. You might look into this..

In an assembly file, right-click the configuration, selectProperties, then under advanced options there is a check box for"Suppress new features and mates" and also a check boxfor "Suppress new components". Play around withthese. It might help.

Good luck!
Like • Show 0 Likes0
Actions
- Devon Sowell @ 1-75IWCO on Jan 23, 2007 3:03 PM
  Hello Tiny-
  
  Thanks for the feedback. Indeed, I did look at those options, and they hadn't changed. The files were created in 2006 and only displayed this problem when Opened and Saved in 2007. Also, these are the only files I've had this problem with, so it appears it was a file specific problem. The cause of the problem has so far not been determined. I corrected the problems and everything is good now.
  Like • Show 0 Likes0
  Actions

Supress & Unsupress Flipping in 2007 SP1.1

Outcomes

Related Content

Recommended Content