10 Replies Latest reply on Jan 3, 2014 3:03 AM by Steven Smith

    Extrude Cut

    Andrew Chaille

      Hi Guys,

       

      I am working on something right now and am having a little bit of difficulty. Perhaps it is the way i am approcahing the design. I know of a way to do it, but i also know that it is poor design intent. When the time comes if i need to edit it, it will be a nightmare.

       

      I need to extrude cut a rectangular shape at an angle. I have taken a picture of what i have so far. I would like it to go all the way through, but have a small amount of space on either side, so it is not two objects after the extrude cut.


      I hope i described this well enough.

       

      Thanks guys