AnsweredAssumed Answered

NPT Thread config

Question asked by Tim Warner on Jan 2, 2014
Latest reply on Jan 3, 2014 by Mike Pogue

First I would like to say I am new to Solidworks. I have been using ProE for 25 years so forgive me if this is a simple question.


I have a sch 40 pipe in which the length dimension is configured. I also have a simple revolved cut on both ends representing the npt.


What I need to end up with is to insert this pipe in an assembly and be able to specify if it is threaded on one end, both ends or not at all.


Is there a way to do this without having to create 3 different configurations for each pipe length?