I am trying to understand what prevents this loft surface from offsetting
I keep getting error unable to offset rebuild errors
Вероятно у тебя извращается поверхность на конусе. Сделай смещение не всей поверхности а лишь ещё части. Место у заострени можно будет залить и скруглить внутри.
sorry mate dont undertand crylic
Try to do your offset without point side (left on your image) . in this point you can't do offset.
It wont allow me either way. Neither outer offset or inner. But after I did few split curves I could off set the subsurfaces. I think it has something to do with the loft profiles. I got what I was tyring to get thanx anyway
Yes. I think differently in any way
It may involve a degenerate surface. If you use a Loft or Boundary to make a surface that is really 3 sided instead of 4 sided, then you get a point where it degenerates and SolidWorks can't figure out the proper surface normal and curvature. In cases like this, it is better to use a Fill Surface, or use Loft or Boundary to generate most of the surface and use a Fill Surface to generate the area that would be degenerate.
you though I was polish?
Retrieving data ...