Matt Halfmann

Mutiple Bends

Discussion created by Matt Halfmann on Dec 28, 2006
Latest reply on Dec 28, 2006 by Gerald Davis
have a sheet metal part that is bent into a basic Z withe 90 deg. corners as opposed to the 45 in the letter. I ham trying to take the flat part and bend it in to the formed view. It is a 2 x 3 metal tube with two V cuts on either side where it will be bent. I can get one side to bend at the 90 but not the other. Any suggestions on what to do. I am using SW '07 SP1.1
I att
Matt
SW'06 SP 1.1
AMD Opteron 175
ATI FireGL V5100

Attachments

Outcomes