hi all......
Why we are using this prarameter in solid works......k-Factor,Bend allowance,bend dedection..wat is the use ??? wat is the difference.....
Informative, previously posted, link in this forum:
http://www.ciri.org.nz/bendworks/bending.pdf
...by Jim Vincent ( https://forum.solidworks.com/people/1-ABKOB2 )
in this discussion:
https://forum.solidworks.com/message/77867#77844
Informative, previously posted, link in this forum:
http://www.ciri.org.nz/bendworks/bending.pdf
...by Jim Vincent ( https://forum.solidworks.com/people/1-ABKOB2 )
in this discussion:
https://forum.solidworks.com/message/77867#77844