AnsweredAssumed Answered

How to show axis in drawing?

Question asked by Pete Lilley on Dec 9, 2013
Latest reply on Dec 9, 2013 by Pete Lilley

Hi Folks,

I am trying to figure out how to show a model axis in a drawing.  I need to pick up the center of a tapered hole, (a cone), from above and can't. The center mark feature doesn't work because the tapered holes break-out on non-planer surfaces on both sides of the part.  I can easily add an axis to each hole in the model but they don't show up in the drawing and thus I can't pick them.  Any suggestions?

TOPVIEW.png

Outcomes