9 Replies Latest reply on Dec 9, 2013 6:08 AM by Juul Van De Leur

    Multible drawing export based on design table

    Juul Van De Leur

      Hello fellow Solidworks users,

       

      Some of the welders at my company asked me to make a flatten for theire tube cut outs.

      I made the flatten cut they requested. This was still pretty easy. But i thought maybe it would be a good idea to make all the possible flatten cut outs possible with a design table.

      Still pretty easy.

       

      Now the problem is: i want all these different configurations as a single new drawing, preffered exported to pdf.

      How do i do this?

       

      As example of a single flatten cut out i have put one attached. The welders print the sheet out. then tape is around the tube and cut away the remaining material.

      It is a DN50 tube under 45 degrees on a DN65.

       

      I called my local solidworks support but they didnt know if it was possible. Maybe with a macro they said.

       

      thx for reading my post