AnsweredAssumed Answered

question about sub-weldment cutlist

Question asked by Jason Dong on Nov 26, 2013

Hi all,

 

i just tried sw2014 and built a simple test model.

basicly, i drew a line and built 3 structure members, there were 2 SHS and 1 CHS.

Then I selected 2 SHS and built a sub-weldment. After that, I updated cut list

As you can see in attached picture,

sw2014.JPG

 

Well, the question is when i built the BOM, it only shows the 1st level of cutlists.

I can see the inherited properties in sub-weldment, but how to show them in BOM?

Is there any setting to set the levels in SW?

 

THX

Attachments

Outcomes