When doing a fillet we are getting leftover sketch entities that cannot be selected and deleted. When the sketch os saved as a DXF file and then opened back up in SolidWorks then the leftover entities show up and can be edited. How do I get rid of the leftovers???
Yes, they were part of the original arcs that were filleted.
Then I would suggest you post the file here so we can try it on our systems and see if the problem persists.
Unfortunately, we cannot send customer files out because of confidentiality issues.
Did you try using the sketch trim command to get rid of them?
What I actually did was delete some Intersection relationships - that deleted the leftover entities. After that there were leftover points but those could be selected and deleted.
Is there a setting that creates an intersection relationship automatically when sketch fillet is used?
this one.
You did not have any extra entities. What you see is the virtual sharp points created by the fillet command. That is normal and actually beneficial.
Those virtual sharps are points that could be represented in a variety of ways. This is most likely your setting:
Again, there is nothing wrong with that. When you export to DXF, they get converted to lines, which, again, is normal.
The fillet command should automatically trim the two line and not leave anything behind. Are you sure the two lines you circled were laying on top of the two line that were used to create the fillet.