ernie lorenzo

Interference Detection

Discussion created by ernie lorenzo on Dec 18, 2006
Latest reply on Apr 10, 2008 by Dustin Biber
Can I print out the Interferencecalculations and show them to my checker for verification of nointerference?

Also...is there a way to check the parts of an assembly forinterference if you want to take into account the tolerance of theparts itself? Say the part is .500" wide - plus or minus .010.Can I use that information to check if the part fits in anassembly? Or do I have to change the part to the minimum andmaximum width it fits or not?

Outcomes