AnsweredAssumed Answered

Property Tab Builder and SWE PDM (2013 SP5)

Question asked by Roman Zhuravskiy on Nov 19, 2013
Latest reply on Nov 22, 2013 by Michael Dekoning

After detail creation in SolidWorks 2013 SP5 I fill properties through Property Tab Builder, then I try to keep in SWE PDM, gives out a mistake..

Save to SWE PDM.jpgThe model in vault doesn't remain.

If I don't use Property Tab Builder in model, everything remains well. But I should make then any changes to model through Property Tab Builder, there is such mistake in the card of data of SWE PDM...

discrepancy of types.jpgHow to eliminate an error?