I'm currently working on a drawing for a fairly complex weldment. All of the welds are 1/4" fillets and all the parts will be welded at every point possible. Instead of calling out the same weld for different parts several times, is there a way to properly call out the entire weldment ("weld all available joints with a 1/4 fillet")?
Hi Justin,
What we have in our General notes on a drawing is weld info (in mm).
'Fillet Weld Sizes Specified are Leg Length (z).'
'All welds Are z8mm continious fillet UNO.'
So the Platers and Welders know that every weld on this drawing is an 8mm fillet unless the drawing shows something diffrent.
Thanks
Mark
Justin,
Here is a screen shot of our typical notes.
Thanks
Mark
Welcome to the forum. I don't know if it's according to any standard, but the screenshot below is probably what I'd do.