My boss and I are trying to figure out a very on and off problem with a sheet metal part. He has redone the design table, config table, and been chipping away at the model for a few weeks now and the problem persists.
The issue is that after working on the file, bend/flatten supressions seem to randomly supress and unsupress. For instance today I changed some part numbers and a logo placement on the part and after saving, and then coming back shortly thereafter the part is fully flattened on 3 of the 4 configurations of a part. only 1 of these four should be flat.
Bossman thinks it is a possible bug since we have been on this for so long...anybody had this experience at all?