2 Replies Latest reply on Nov 18, 2013 11:18 AM by Shawn Casebolt

    Removing a font

    Shawn Casebolt

      I have a colleague who refuses to stop using Comic Sans on his drawings.  Our mgr is slowly trying to beat him into submission, but it is a sensative subject as the person in question was once in charge, etc.. 

       

      Therefore I would like to just make that font unavailable to him.  However from what I found Solidworks uses the default windows directory so if I remove it from there, then I assume he will not be able to use it in any other program.   Which is not the intent.

       

      Anyone know a way to block this font from SW?  I wish I could get him from jacking the font size up so he can see it too, but thats another battle.  First to get his drawings to look like everyone elses and not  some joke.