I just upgraded to SW 2014 from 2013 SP04 and now am getting the Toolbox error below. I know this is because I copied a few standard fastener types in 2013 and added part numbers and discriptions required in our BOMs. I did copy the folder from 2013 containing the copied and modified fasteners to the new (2014) browser folder but when I go to the Toolbox in the design library the copied fasteners do not show up? Can someone please tell me how to add these fasteners to the new SW 2014 toolbox so the assemblies can find them and I can use them?
The Toolbox component (B18.3.1M - 12 x 1.75 x 45 Hex SHCS --
45CHX) referenced by this assembly was not found. It cannot
be automatically created because this component does not
exist in your Toolbox.
Would you to find it yourself?