3 Replies Latest reply on Nov 8, 2013 2:56 PM by Jared Conway

    Is it possible to "expand" the symmetry?

    Mildred Mattice

      Say I want to analyze a force on a 3D square cube.

       

      I use symmetry by cutting the cube into an eighth (top right corner block): put symmetry on the left, bottom, and rear.

       

      Is it possible, after analysis, to expand this symmetry so that I can view the full cube, instead of just block (an eighth of what it is)?

       

      I have used ANSYS, and ANSYS allows this type of view... just wondering if Solidworks has this type of feature.