AnsweredAssumed Answered

Using the Convert Entities tool to subtract geometry

Question asked by Tom Hunt on Nov 5, 2013
Latest reply on Nov 5, 2013 by Tom Hunt

Hi, I'm quite new to using SolidWorks.  For a particular project, I am supposed to use the Convert Entities tool to cut a slot out of an extruded sketch.  I looked around on YouTube but did not come accross any videos showing how this could be accomplished. 

 

Below is an example of the sort of notch I am trying to create using the Convert Entities tool.  How would I go about doing this?

 

notch_pic.jpg

Outcomes