4 Replies Latest reply on Nov 6, 2013 2:26 PM by 1-4EQZK9

    Why do I keep getting edges when cutting with splines?

    Andi H

      I dont understand this. Why do I keep getting multiple edges when cutting with contious spline?

       

      the spline is on center plane and it is aligned to curve I got from surface edge using the convert entities.

       

      Capture.JPG

       

      now when I do sufrace blend instead of cutting the edge and getting on contious edge in the shape of spline I get little nudges? Why

       

      Capture2.JPG

       

      Is the problem with the curvature aligment of the spline its going out side the surface when I do Curvature relation?

       

      Capture3.JPG

       

      every time I cut with a curvature aligned spline I keep runing over and over on same problem