7 Replies Latest reply on Oct 25, 2013 4:31 PM by J. Mather

    Help wanted.

    Kyle Lee

      Hi everyone.

      I am a new learner. I have an assignment that requires me to build a wallmounted coat hanger. It must hold 50lb at least.

      I have drawn my hanger as 1 part only, and im stuck in the simulation step. I can't get it run because of the "Meshing failed" issues. I tried many ways posted here but nothing worked. In my failure diagnosetic, it said that my whole part is the problem (I was expecting it to say an edge or a surface). I re-drew it many times and still not work.


      I uploaded my drawing here. If anyone can do the simulation with this please tell me how and what I did wrong.

      Thank you.