AnsweredAssumed Answered

Derived Part and Tolerancing

Question asked by Jim Lins on Oct 22, 2013
Latest reply on Oct 22, 2013 by Tim Smith

Good morning all,

 

I have a part which is finished machined from a casting.  What I did, was build the casting as a model, then bring it into a new part so that it can be machined away (just like in real life).  While modeling the finished piece at nominal, I noticed cleanup issues.  I would like to know if there is some easy way in SwX to make the dervied part go to LMC while toggling the machined piece to MMC or vice versa.  Or have both at LMC and MMC.  I just want to be able to toggle both models between LMC & MMC.  I haven't found a answer while searching, so any help is appreciated.

Outcomes