Is there any easy way to find out the volume of this hobber in SW?
You can go to tools,mass properties
You need to have a solid body to find the volume
I am not aware of any easy method
If you are looking for an accurate figure, you can create inside surfaces, close top and bottom, sew together to make a solid.
This looked pretty easy to me.
363030565.00 cubic millimeters (I didn't include the fillets, but easy enough to add them, or should I say, remove them from the volume)
Volume = 0.36 cubic meters
Can you please tell me how did you calculate? Can we do it from SW?
Thank you very much George and Maher.
Retrieving data ...