I just installed SP 4 on 2013. Now planes will not mate for some reason. Any suggestions? There is no error message when trying to mate two planes. The selection box in the feature does not even pick it up or recognize it.
Are you able to pick other things? Can you mate faces? Do check if selection filters are on.
No filters are on. There is no box in the options to check or uncheck based on mating planes.
Also I can mate everything else
I don't have any experience with them, but from reading other posts here I believe you can get strange behavior with Radeon graphics cards. That might be a possibility. Also, have you re-booted since this behavior started? And have you tried selecting the planes from the tree or the graphics area?
Yes I have the AMD Firepro. It's a good card but not as good as the Quadro. I've rebooted and also selected the planes from the tree. I will see about graphics drivers.
Seems to work OK for me. I'm running SP5.0EV but I mate between planes frequently when I'm populating PCB's and I don't recall encountering that problem when I was on service pack 4
Retrieving data ...