Hi does anybody know why i can't seem to paste in my 2d geometry from the draftsight clip board anymore? It used to work but has stopped working for some reason. I did reccently get the lastest version of Draftsight uploaded.
Same issue here. I have noticed that it works for my co-workers with an older install of draftsight.....I am on Version V1R4 x64.
Per my VAR: SolidWorks has informed us that this is a known issue (SPR 722198) affecting newer versions of Draftsight, including V1R14. As a temporary workaround, you can open the DXF or DWG file in SolidWorks, cut and paste the entities you need, then close the DXF/DWG file without saving.
Bryan and Kerry,
I think you can also roll back to a V1R13.1.
I have started opening the .dwg or .dxf in Solidworks and copying and pasting from there. It doesn't seem to want to work at 2013 so I save it as a R14 and it works fine. Thanks
We just updated to V1R15 in the hope that this issue would be fixed. It is NOT. We have changed our default save to R2010. Soildworks can open the R2010 version of the drawing. Then we can copy from it and paste it into a SW sketch.
Retrieving data ...