is it possible to insert a surface finish mark into a hole callout??
Check the video here on how you can insert the symbol in a note. Same thing is applicable for hole call out.
ya that works for a note. it does not for a hole callout or dimension.
Works for me.
please show me then? there is no surface finish in the symbols list for a dim
Steve, you can insert symbol into the hole callout when that is created/inserted automatically on view insertion. If you use hole callout then that is a dimension. The only way to insert symbols with dimensions is to make your own in case they are not in the list.
I know when you go to put the surface finish symbol on the hole callout leader it shows a red circle with the line thru it. I usually just put it near it then move it close. I don't think there is a way to tie the two together.
i usually do the same. would be nice if they could tie together as in a note tho. thanks for your reply
Retrieving data ...