Good day all. Can I set SolidWorks to default to a single body sheet metal part as in past releases instaed of defaulting to a multibody part?
Good day all. Can I set SolidWorks to default to a single body sheet metal part as in past releases instaed of defaulting to a multibody part?
We hate this too! We don't and will never use multi-body sheetmetal parts, yet we have to deal with this
X3 this stinks, they should offer in system option a check box to run it the old way if you choose too.
Correct guys. This is not a design concept we would ever use either. While it may be a nice OPTION for some people, as a default setting however, it lacks a lot of forethought.
I think the multi-body works if you are not to sure in SheetMetal and end up grafting a piece on here and there.
For me if it's more than one part its an assembly.
Amen!
"For me if it's more than one part its an assembly."
AFAIK, no.
For more information: http://www.javelin-tech.com/blog/2013/04/alins-sw-2013-sp3-0-pick-of-the-day-total-control-for-the-bend-allowance-in-multibody-sheet-metal-parts/