i made this drawing in sw 2013
i want to mate 2 and 3 and also to stop lever at 4 but when i mate 2 with 3 lever had stop working
and pls help me how to stop lever 1 at 4
Hope this below assembly will be useful for you. for the same thing again you can limit mate the distance through advanced mate and you can achive the required result.
Please see attached model here with
pls jaldi reply karna i need it urgent
and if any could help is possible to animate this spring
ANY ONE HELP
bro how to stop lever at 4
I already told you in last reply, that you need to give distance limit mate.
Check below assembly. I implemented the same.
Hope it will help you.
bro u use tnagent mate ....
on shaft by making revolve face at 3
kya koi or method nahi hai use karne kaa
Dear Ankush, that was to avoid interference in between components. Presently I dont see any alternative to tackle that tangent mate requiremnt.
But ultimately I do feel your requirement is not to avoid tangent mate, but is not to show that spherical dome shape at end.
Please check below assembly updated. Hope this will satisfy your requirement.
Dont mind just a suggestion, as there will be theoretically a single point contact in between bore pin and lever, it may cause huge wear and tear of both the components. suggested to make use of dome shape as I prepared earlier which interms will help you to reduce the consequences.
Retrieving data ...