Good morning,
this is my first large assembly i have made, i have mated all the components together and now i cannot seem to get it to move! when the ram in the middle moves the motor should open and close but the only part i can get to move is the top rail. can someone explain where i have gone wrong? perhaps i should mention there are no sub-assemblies and also this was converted from a .step file (if that will make any difference?)
any help would be greatly appreciated.
many thanks
Troubleshoot the mating scheme by suppressing all the mates and all the components but the first one.
Now, unsupress them one by one and make sure that they move the way you intended. If not, adjust the mates.