AnsweredAssumed Answered

Drawing file ID in BOM

Question asked by Piotr Dabrowski on Sep 13, 2013

Hello,

 

is it possible to exhibit drawing file ID in assembly drawing BOM table?

It's quite obvious that SW offers only 3D model ID data, because BOM table use information linked with models - not with drawings. However try to imagine situation where two or three drawings (which different tollerances, using other projection system etc.) are in reference with one model ...

I need to put 2D File No. into BOM table as well, to be absolutly certain that correct drawing will be listed (will be sent to supplier).

 

Maybe it's impossible and only an extra add (e.g. macro) will be necessary?

 

Thank you in advance for any info!;-)

Outcomes