Since creating a second extrude cut im not able to fold part. For the second cut a placed a second unfold before the cut and tried to place a fold after the cut.
Thanks for any advise you can give me.
Your cut eliminates the edge that is used for your flatten feature. Edit your flatten feature and take note what model entity is in the "fixed face" under selection. In order to use flatten & fold you must make sure that the edge or face that was used for the flatten feature remains in the model or fold will fail.
I have the same problem with folding. I’m doing this 2 timeson 1 part. First I unfold, make cuts and fold again. Then I unfold again andmake the same cuts on other side. After that I can’t fold again.
If I make both cuts after first unfolding I can’t fold either.
Can somebody tell me what I’m doing wrong?
Retrieving data ...