SolidWorks say something about a Mother view. But importing it into a Drawing do not work.
Welcome to SolidWorks forums Michel.
When you save section view in part/assembly then make sure you choose Drawing annotation view.
Then in the drawing, in the View Palette you should see view(s) with section arrows. That is the parent view you need to insert first and only after that you can put the section views saved in part/assembly.
You might also find this post helpful for your future reference.
Thanks a lot.
This was the little trick behind this one.
I tried this but couldn't import section view from model to drawing.
I saved required secton view in model (assembly) with Drawing annotation view.
When I go to drawing, View Palette is gray out. The only thing I can import is Model View. Even if I import model view and later make a section view from it, I'm not able to show section view from model.
I might done something wront so if you have any idea pleasae let me know.
It took me a couple tries to figure this out.
Make sure you refresh your view pallet.
Select the view with the section cut arrows.
Insert into your drawing.
Then you can even rotate it into an isometric view if desired.
Retrieving data ...