How do I trim this extra piece of this angle?
your help is appreciated.
It depends on how the part is being trimmed now. If it is part of the same structural member (just a different group) and you want it trimmed automatically in the feature you could use a weld gap where the 3 angles come together. It would need to be big enough to cut through the radius that is currently extending (maybe a 1/16").
If you used the Trim/Extend command then instead of using the trim to body option use the trim to face/surface and select the flat edge of the angle next to the radius. Make sure to uncheck "Allow Extension" in the command.
This caught an old coworker of mine as the welders made the pieces from the cut list lengths and welded everything together before checking the actual height against the drawing.
If the Trim/Extend feature won't work, you may need to do a simple Extruded Cut, selecting that single body for the Scope.
Edit the part and extrude cut the portion you do not require.
thank you guys for the help.
Retrieving data ...