11 Replies Latest reply on Aug 22, 2013 6:02 PM by Jared Conway

    Flow trajectories in a chamber

    Omid Omidi

      Good afternoon!

       

      I am sitting with a problem which is about a very simple flow simulation inside a chamber. (Diameter=7mm   Hight=3mm)

      After running the simulation, when I try to draw flow trajectories, they never reach to the bottom of the chamber. I increased the number of  lines(up to 1000) and the same problem.

      1.png2.png

       

      I imported the geometry to COMSOL and ran the simulation and in comsol, the streamline results ae much better and they reach to the bottom of the chamber and side walls.

      I was wandering if anyone could help me to fix this problem in solidwork. Is there any setting that i have to change or modify?

       

      Thank you every one!