I have been trying to re-origin this imported part. However, had no luck.
Please guide.
where do you want the origin to be?
do you want it to stay an assembly, or end up as a multibody part?
Jeremy,
I would want this to stay as an assembly.
ok - where do you want the origin to end up?
My apology, all I would want is to origigin XYZ of part. Where the front face of part would be Z axis.
right and bottom edge of part would be X & Y.
try this.
where do you want the origin to be?
do you want it to stay an assembly, or end up as a multibody part?