hi guys ... again
i have stuck with my front painel .. strutural member can´t aply weldment in sketch 3d , who was made from projected curve
or better way to do this??
anione can help me pls
i attach the file
The projected curves are not true arcs and would involve 'bending' the tube in two directions simultaneously. That's something which SW cannot currently perform in the Weldments mode. SW has a similar limitation in it's sheet metal mode.
Use a regular sweep.
but if goes with sweep is not gona show in BOM
After Updating your Cutlist the sweep should show up. At least I assume so. I add Boss-Extrudes to Weldment parts all the time and they show up in the Cut List. Of course some of the cut list properties won't fill in automatically.
Retrieving data ...