AnsweredAssumed Answered

Block Dimensions in Drawings

Question asked by Colton Schenk on Aug 9, 2013
Latest reply on Aug 9, 2013 by Christopher Estelow

I have a question I can't seem to find the answer to. I have set a limit dimension in a sketch block. I used the block for an extrude cut (connector cut out). I am now making a drawing for machining, I would like SW to display the Limit Dimension tolerance I have already set up in the block. Is this possible? Or do I have to do the leg work of re-inserting the limit dimensions in the drawing?