I'm trying to set up a template for sheet metal parts that will pull the data out of the bounding box on a sheet metal part and put it into a drawing.
Any advice on where to pull this from?
Tim, See these threads
These properties are in the cutlist properties.
I am still playing around with these sheetmetal linked properties and BOM's.
But this info may get you started,
Its been a while since I reconfigured templates...etc. Any chance you could send over your sample part? firstname.lastname@example.org
The reference threads which I have mentioned earlier, have stated that adding these cutlist parameters to a BOM cannot be done. That I cannot disagree with.....yet because I have not thoroughly investigated these parameters. In case you can use them somehow, I have attached the sample part and the sample part drawing that I come up with the other day.
Retrieving data ...