please check attached assembly and motion study 01. I have tried but motion sequence is get disturb itself whenever i rebuild the assembly.
You might want to move this question to the SolidWorks Simulation/Motion forum. You can move it to that forum in the Actions box at the upper right. If you like, you can leave the question here and just ask again in that forum.
could you elaborate on the problem?
what version and service pack are you using?
i opened the model in 2013 sp4.0 and there is a rebuild warning immediately, several of the mates seem to constantly need rebuilding which could be part of your issue. i'd solve that first.
then i looked at your motion studies. neither of them had any motion information in it. that being said, when i open motion study 1 it does ask about moving the components because of changes. is that what you are talking about? that would be related to the rebuild.
Retrieving data ...